Sterling Plumbing 6065 Install the Pile Seal, Install the Panel Guide, Crimp here on each end

Inside Panel

Guide Bushing

Installed

			Inside
			Panel
Bushing	Inside Panel	Panel	#8-18 x 3/8"
	Guide
		Frame	Panhead
		Screw	Screw

	Inside	Screw
Pile		Cover
	Panel
Seal	Guide

Bushing

Screw

Cover

Crimp here on each end.

14. Install the Pile Seal

Install a bushing into one end of the inside panel guide.

Measure the length of the panel guide, subtract 1″ (2.5 cm), then cut the pile seal to the resulting length.

Slide the pile seal into the panel guide.

Install a bushing into the other end of the panel guide.

Use a pliers to crimp each end of the panel guide to keep the bushings from sliding off.

15. Install the Panel Guide

NOTE: Perform these installation steps from inside the shower.

Install the panel guide in the opening of the bottom track.

Align the slots on the panel guide with the holes in the inside panel bottom frame.

Loosely thread two #8-18 x 3/8″ panhead screws through the guide and into the frame. Do not tighten at this time.

Push the panel guide all the way into the bottom track.

Lower the guide slightly for clearance and tighten the screws.

Move the panel back and forth along the full width of the opening.

If the panel sticks, loosen the screws and adjust the guide. Repeat until the door operates smoothly.

Install screw covers over the panel guide screws.

Sterling 13 1035946-2-B