Sterling Plumbing 6065 Install the Rollers - Inside Panel, Install the Rollers - Outside Panel

Roller

Handle Side

of Door Panel

Side Frame

#8-32 x 3/8" Hex Washer Head Screw

#8-32 x 3/8" Hex

Washer Head

Screw

Groove

Top

Frame

Flange Tape

Bushing

Tab

Bushing

Installed into the

Bottom Frame

Outside Panel

Bottom Frame Leg

Inside PanelOutside Panel

11. Install the Rollers - Inside Panel

NOTE: The steel side of the roller must be installed against the top frame ¯ange.

Place the rollers on the top frame ¯ange, facing the handle side of the door panel side frame. Secure the rollers with #8-32 x 3/8″ hex washer head screws.

12. Install the Rollers - Outside Panel

NOTE: The steel side of the roller must be installed against the top frame ¯ange.

Place the rollers on the top frame ¯ange. The roller should face the bottom frame leg. Secure the rollers to the top frame ¯ange with #8-32 x 3/8″ hex washer head screws.

Lay the outside door panel on a ¯at surface taking care to protect the glass.

Cut two 7/8″ (2.2 cm) long pieces of the provided adhesive tape.

Remove the protective paper from the adhesive side of the tape and attach the tape to the bushings. Locate the bushings 1/4″ (6 mm) from each end on the bottom frame of the outside panel.

With the bushing tab toward the bottom frame groove, pinch the bushing legs together and push down until the bushing tab snaps into the bottom frame groove.

Sterling 11 1035946-2-B