Sterling Plumbing 882.00252.00, CV3-635 Logging On and Logging Off, Password Entry Screen

Logging On and Logging Off

Your controller may be set up to require a password for any operation (other than reviewing station and pump status, silencing alarms, reviewing the alarm log, and looking at help screens). If so, touching a button will open the “Password Entry” keypad screen.

Figure 13: “Password Entry” Screen

Enter the four-digit password (including any leading zeros). For example, if the password is 1, enter 0001.

Each digit appears as an “X” as you touch it. When you touch the fourth digit, the controller carries out your request. For example, it enables or disables the requested pump or station, or it goes to the “Station Operator” screen. If you did not enter the correct password, the controller erases the entry. You can then try again. To give up, touch Return.

Note: If you have lost the password(s), contact us for assistance.

Once you have logged on, the password remains active until you log off or the password expires. (Setup personnel at your facility control the number of minutes before the password expires.) While the password is active, you can continue to carry out password-protected tasks without reentering the password. If the timer expires, the controller goes to the “Station Status” screen and you must reenter the password to continue working.

When you have finished any tasks that require the password, you should log off. (If you forget to do this, the controller will log you off when the password expires.) To log off, complete the following steps:

1.Go to the “Menu” screen by touching Menu from any other screen.

2.Touch Log Off Password. The “Station Status” screen opens.

3–Pump 33-Station Controllers Chapter 4: Operation 31 of 51