Sterling Plumbing CV3-635, 882.00252.00 specifications Station Alarms, Pump Alarms, System Alarms

7-2 Alarms

The format for all station alarms is “Station n [alarm text],” for example, “Station 12 receiver low level.” The format for all pump alarms is “Pump n [alarm text].” Any alarm that does not start with “Station” or “Pump” is a system alarm.

The following tables list all alarms alphabetically, together with possible causes. A “critical” alarm is one that causes the affected device to stop.

Note: You can also see a list of alarms and their causes in the controller’s online help. To display this information, touch the color key of statuses in the upper right-hand corner of either the “Station Status” or the “Pump Status” screen, or touch Help at any other screen. When you are finished reviewing the help, touch Return.

Station Alarms

Alarm message	Possible cause
	Material line is blocked.
	Vacuum line is blocked.
High vacuum	Convey time is too long (time-fill station only).
	Sequence valve has malfunctioned.
	Vacuum switch has malfunctioned.
	Note: After you have corrected the cause of this alarm, the alarm will be
	cleared when the controller has conveyed a full load to this station.
	Material container is empty.
	Material line is disconnected from material source.
No convey	Vacuum line is disconnected from station.
	Take-off compartment is not adjusted properly.
	Convey time is too short.
	Note: As a stopgap measure, you can disable the “no convey” alarm for
	this station until the problem can be remedied. See pp. 43.
Not assigned (Critical)	Station has not been assigned to a pump

Pump Alarms

Alarm message	Possible cause
Pump failure	Circuit breaker or overload protector has tripped.
(Critical)	Contactor has malfunctioned.
Pump fault	(Function determined by your facility.)

System Alarms

Alarm message	Possible cause
Low battery	Battery for the controller is defective.
	Battery for the controller is old and drained.

3–Pump 33-Station Controllers Chapter 7: Troubleshooting 46 of 51