To change the duration of the password, complete the following steps:
1.On the “System Setup” screen (Figure 4), touch the Operator Password Duration button or the Setup Password Duration button, depending on which password duration you want to change. A keypad pops up.
2.Enter the number of minutes (between 1 and 99) that you want to set as the password
duration. Use 
(Backspace Key) to erase any mistakes. Use 
(Enter Key) to enter the value. The keypad disappears, and the “System Setup” screen shows the new setting.
3-5 Initial Startup
Once you have finished all the setup described above, you are ready to start the system. To start your system, complete the following steps.
1.At any screen, touch Menu on the right side of the screen. The “Menu” screen appears (Figure 2).
2.Touch Stations. The “Station Status” screen appears (Figure 5).
3.For each station that you want to use, briefly touch its icon. The icon turns blue, indicating that the station is ready, or the icon turns yellow, indicating that the station needs material.
4.Touch Pumps. The “Pump Status” screen opens (Figure 8)
5.For each pump that you want to use, briefly touch its icon. The icon turns blue, indicating that the pump is ready.
6.Touch Push to Start System in the lower
7.The system starts. If any alarm messages appear on the screen, see p. 45.
Chapter 3: Installation | 27 of 51 |
