Stiga 4WD manual Assembly, Controls, 92/107 M, Controls, 121 M, Installing the 110/125 Combi Pro

ENENGLISH

2.3.3 Rear mounting

The cutting deck’s rear section is secured with the pins in fig. 13.

2.4 Controls, 92/107 M

2.4.1 Cutting height adjustment

The cutting height can be adjusted between 30 and 85 mm.

The setting can be adjusted to a number of fixed positions using the lever. See fig. 9.

2.4.2 Incline forwards

The cutting deck’s rear section can be raised infi- nitely variably.

Each line (12:J) corresponds to a raise of 5 mm. The setting is locked with the screws (12:K).

2.4.3 Rear mounting

The cutting deck’s rear section is secured with the catches (12:L).

2.4.4 Mounting in implement lifter

The deck is mounted in the implement lifter with a chain and snap hooks.

One snap hook is intended for the working position and can be moved in the chain links to set the lift- ing force.

The other snap hook is intended for the washing position.

2.5 Controls, 121 M

2.5.1 Cutting height adjustment

The cutting height can be adjusted between 30 and 85 mm.

Electric cutting height adjustment

The setting can be adjusted infinitely variably us- ing a switch on the machine.

Manual cutting height adjustment

The setting can be adjusted to a number of fixed positions using the lever (7:G).

2.5.2 Incline forwards

The cutting deck’s rear section can be raised infi- nitely variably.

The setting is locked with the screws (7:H).

2.5.3 Rear mounting

The cutting deck’s rear section is secured with the pins (7:I).

3ASSEMBLY

3.1Installing the 110/125 Combi Pro

1.Place the cutting deck in position in front of the machine.

2.Install the following components on both wheel axles:

•Washer (3:B).

•Deck mount (3:C).

•Washer (3:B).

•Circlip (3:A).

3.Remove the pins and the washers on both sides. See fig. 2.

4.Screw the arms into each other. See fig. 4.

5.Suspend the cutting deck in the implement lift- er. See fig. 14.

6.If the deck has electrical cutting height adjust- ment, connect the cable to the machine’s front right socket. See fig. 15.

3.1.1 Belt, 110/125 Combi Pro

The cutting deck’s rear section should rest on the floor (it should not be lifted or secured).

Install the belt as follows:

1.Set the maximum cutting height.

2.Remove the belt cover (5:E). The number in the figure indicates the key width.

3.Remove the belt guide (5:F).

4.Locate the belt around the machine’s belt pulley (16:M).

5.Force the belt onto the cutting deck’s belt pul- ley.

6.Grip the belt tensioner’s lever with your left hand. Pull the lever and apply the tensioner to the outside of the belt with your right hand. See fig. 16.

7.Install the belt guide and belt cover. See fig. 5.

8.Lift up and secure the rear section of the cutting deck.

On machines with 17” wheels: Install the wash- ers and the pins in the top hole. See fig. 2.

On machines with 16” wheels: Install the wash- ers and the pins in the middle hole. See fig. 2.

34