A.Assemble all "O" Rings onto parts dry, without lubri- cation. Then apply a thin film of sanitary lubrication to exposed surfaces of the "O" Rings. Apply a thin film of sanitary lubricant to metal part of rear seal. Also apply a thin film of sanitary lubricant inside and outside of the front auger support bushing.
B.Assemble the rear seal onto the auger with the large end to the rear. Be sure the "O" Ring is in place before installing the rear seal.
C.Lubricate the auger drive (rear) with a small amount of white socket lubricant. A small container of socket lubricant is shipped with the freezer.
D.Screw the springs onto the studs in plastic flights.
Springs must be screwed into the flights com- pletely to provide proper compression (Fig. 25).
I.Install the front door on the freezer studs, then hand tighten the circular knobs.
CAUTION
FINGER TIGHTEN THE CIRCULAR KNOBS EVENLY. DO NOT OVERTIGHTEN KNOBS.Look for the proper seal between the freezer barrel, "O" Ring, and front door.
K.Install the mix inlet regulator into the freezer with the air tube to the front of the freezer (Fig. 27).
L.Install hopper cover and drain tray.
CAUTION
DO NOT PLACE THE MIX INLET REGULATOR INTO THE HOPPER BEFORE INSTALLING THE AUGER.
E.Install the two plastic flights onto rear of the auger and insert part way into freezer barrel.
F.Install the remaining plastic flights, push the auger into the freezer barrel and rotate slowly until the auger engages the drive shaft.
G.Install the bushing and auger support into the front of the auger with one leg of the support pointing straight up.
H.Install the spigot body with "O" Rings into the front door from bottom (Fig. 26). Push straight up until the spigot is in place.
To remove spilled or dried mix from the freezer exterior, simply wash in the direction of the finish with warm soapy water and wipe dry. Do not use highly abrasive materials as they will mar the finish.
13