6" (15cm)

Figure 5. Mix Hose Installation

2.5 MIX PUMP

A.Mix Pump Hose Installation

Follow the steps below to install the mix pump hose.

1.Turn pump on.

2.Feed one end of mix pump hose into the entering or pick-up hose side (left) of black cover.

3.Gently push the hose into the black cover until it begins to feed.

4.Allow the hose to feed itself thru the pump until 6" (15cm) remains on the entering side.

5.Turn pump off.

6.Connect mix pump hose to the elbow fiting (located on the left side of the mix line manifold) using small hose clamp. Be careful not to twist the mix hose.

7.Turn pump on.

8.Allow remaining 6" (15cm) of tubing to feed thru pump until hose adapter prevents further feeding.

9. Turn pump off.

10.Connect free end of mix pump hose to 3-way Tee as shown in Figure 6. When all connections are complete the 3- way Tee must be lower than the black pump housing (see Figure 6).

CAUTION

Risk of product damage

Air/mix Tee must remain below the black cover/clamp. If Tee is above the pump, mix will drain to the air compressor resulting in pump damage.

B.Mix Pick-up Hose Installation

The F431 freezer may be connected to standard mix containers or prepacked mix bags. One, 5 gallon mix bag may be connected to each freezing cylinder or two, 2 1/2 gallon bags may be connected on each side. Follow the instructions below that match your configuration.

When Using One Mix Container Per Side:

1.Connect 2 inch (5cm) length of 3/8 inch (9,5mm) I.D. plastic food grade tubing to the mix pick-up assembly. Secure with hose clamps. Then place assembly thru hole in cover and install retaining clip (see Figure 6 and 7).

5