Installation
(DE100i-SW only)
1.Attach the I/O cable from the rear distribution board of the DE100i-SW carrier to the disk drive (Figure 6A).
2.Attach the 4-pin DC power cable from the rear distribution board to the disk drive (Figure 6A).
3.Install the 5-pin ID select cable into the rear signal distribution board connector. Refer to Figure 7 for a typical 2mm drive pin connection.
4.Carefully insert the drive into the carrier at an angle, cable-end first. Make sure that none of the cables are pinched. Lower the front of the drive carefully into place. Fasten the drive into the carrier with four (4) #6-32 Phillips Flat Hd. screws provided.
5.Attach the provided cable cover with two (2) #6-32 Phillips Flat Hd. screws.
Figure 6A: Drive Installation Assembly
(DE100i-SW)
DE100i-SW/SWC User's Guide - Rev. G01 | StorCase Technology, Inc. |
