SERVICING INSTRUCTIONS
REPLACING PARTS
9.3Undo the two screws at the back of the firebox and carefully withdraw the bracket.
15
AR1607
9.4Disconnect the two slender wires. Undo the two taptite screws and remove the sensor and the two plastic spacers. See diagram 16.
16
AR1446
9.5Refit the new sensor, ensuring that the plastic spacers are between the sensor and the bracket. Refit the leads. See Diagram 17.
17
18
AR1448 | AR1447 |
9.6Feed the cable back through the hole as you replace the bracket. When the bracket is located correctly it will sit flush with the back panel without force required. If not positioned correctly the bracket will sit at an angle. See Diagram 18.
10.PRIMARY AERATION PLATE
10.1Turn the gas supply off at the isolation device.
10.2Refer to Section 2 to remove the main burner.
10.3Remove the two screws on the burner skin to detach the venturi cover from the venturi. Slide the venturi cover off the venturi as per diagram 19.
19
AR1608
10.4Change the aeration plates to those stated in the technical specification for the gas the product will be using, refer to the databadge.
20
AR1452
AR0619
20
