Stovax P8050 manual User Instructions, cleaning the STOVE, fuel bed arrangement

USER INSTRUCTIONS

4.2• Hold in the control knob and rotate anti-clockwise until the knob is pointing at the ignition symbol ( ★ )

• Apply a lighted match to the pilot hood, Diagram 3

3

AR0897

4.3When the pilot is lit:

• Extinguish the match and continue to hold in the knob for 5 to 10 seconds

4.4• Close the door and tighten the bolt and nut with a spanner

4.5The fire can now be operated as previously described.

5. cleaning the STOVE

WARNING: DO NOT ATTEMPT TO CLEAN THE STOVE UNTIL IN A COLD CONDITION. THE STOVE RETAINS ITS HEAT FOR A CONSIDERABLE TIME AFTER SHUTDOWN.

ADVICE ON HANDLING AND DISPOSAL OF FIRE CERAMICS

The fuel effect and side panels in this appliance are made from Refractory Ceramic Fibre (RCF), a material which is commonly used for this application.

Protective clothing is not required when handling these articles, but we recommend you follow normal hygiene rules of not smoking, eating or drinking in the work area and always wash your hands before eating or drinking.

To ensure that the release of RCF fibres are kept to a minimum, during installation and servicing a HEPA filtered vacuum is recommended to remove any dust accumulated in and around the appliance before and after working on it. When servicing the appliance it is recommended that the replaced items are not broken up, but are sealed within heavy duty polythene bags and labelled as RCF waste.

RCF waste is classed as stable, non-reactive hazardous waste and may be disposed of at a licensed landfill site.

Excessive exposure to these materials may cause temporary irritation to eyes, skin and respiratory tract; wash hands thoroughly after handling the material.

5.1 • Release the door as described in section 4.1

5.2• Remove the ceramic coals, rear panel, fuel bed and burner cover gasket

•Handle these components with care as they are fragile

5.3The ceramic coals and fuel bed can be cleaned using a vacuum cleaner with a soft brush attachment. It is advisable not to clean the cover gasket as this is very fragile.Ensure all debris is removed from the burner ports.

5.4• Replace the ceramics, referring to section 6.

6.fuel bed arrangement

6.1• Place the white ceramic cover gasket onto the burner

•Ensure the holes align with the burner ports, Diagram 4.

4

AR0898

6.2• Place the fuel bed over the burner, tallest part towards the rear of the firebox, Diagram 5

5

AR0899

6.3• Carefully feed the rear panel into the firebox and engage it between the two locating brackets

•Slide the panel down behind the fuel bed, Diagram 6

5