Stow SCT36, SCT46 Safety StopWire, Engine Safety Stop Wire Connection Pitch Cable Installation

SCT SERIESTROWEL — ASSEMBLY AND INSTALLATION

Safety StopWire

Locate the SAFETY STOP wire protruding from the handle tube (Figure 8) and connect it to the tail wire on the engine. Test the safety stop switch to insure proper operation.

Figure 8. Engine Safety Stop Wire Connection

Pitch Cable Installation

Figure 9. "No Pitch" Position

Figure 10. Blade Pitch Cable

2.Remove one brass set nut from the blade pitch cable end as shown in (Figure 10).

3.Thread the second brass set nut towards the cable as far as possible.

4.Insert the cable end through the yoke eyelet (Figure 11) Tighten the first brass set nut by hand to remove all the slack from the cable.

YOKE
THREAD CABLE END
THROUGH YOKE EYELET
TIGHTEN SECOND
BRASS SET NUT	USE A WRENCH TO
AGAINST YOKE BOSS	TIGHTEN FIRST BRASS
	SET NUT AGAINST YOKE BOSS

Figure 11. Cable Yoke Attachment

1.Expose the pitch cable to maximum by adjusting the handle pitch to the "no pitch" position. On the standard model turn the pitch control counter-clockwise, (Figure 9).

5.Using a wrench, tighten the second brass set nut up against the yoke boss.This will lock the cable in place.

6.Use a wrench and finish tightening the first brass set nut up against the yoke boss.

SCT SERIES WALK-BEHIND TROWEL — PARTS & OPERATION MANUAL — REV. #4 (04/02/07) — PAGE 19