SCT SERIESTROWEL — INITIAL START-UP

3.Placethe centrifugal safetystopswitch (Figure19)inthe "ON"position.

CAUTION

NEVER disable or disconnect the centrifugal safety stop switch. It is provided for the operators’ safety and injury may result if it is disabled, disconnected or improperly maintained.

Figure 19. Centrifugal Safety Stop Switch

Figure 21. Starter Grip

6.If the engine has started, slowly return the choke lever (Figure 20) to the "OPEN" position. If the engine has not started repeat steps 1 through 5.

7.Before the trowel is placed into operation, run the engine for several minutes. Check for fuel leaks, and noises that would associate with a loose guard ring and/or covers.

8.To begin troweling, move the throttle lever (Figure 22) toward the "RUN" position by pulling back toward the operator..

4.Place the Choke Lever (Figure 20) in the "CLOSED " position.

Figure 22. Throttle (Run Position)

Figure 20. Engine Choke Lever

5.Grasp the starter grip (Figure 21) and slowly pull it out.The resistancebecomesthehardestatapositioncorresponding to the compression point. Pull the starter grip briskly and smoothly for starting.

SCT SERIES WALK-BEHIND TROWEL — PARTS & OPERATION MANUAL — REV. #4 (04/02/07) — PAGE 23

Page 23
Image 23
Stow SCT36, SCT46 operation manual SCT Seriestrowel Initial START-UP