Stow SHS62A CUT-OFF SAW - WATER KIT INSTALLATION INSTRUCTIONS, Contents of Water Kit, to the

SHS62A CUT-OFF SAW — WATER KIT INSTALLATION INSTRUCTIONS

Figure 9. Water Kit Parts

Figure 10. Water Kit Assembly Points

Contents of Water Kit

The contents of the Water Kit cannot be purchased seperately. See Water Kit Assembly in Parts Section of this manual for Water Kit part number.

Hose Clamp G
Socket Head Cap Screw w/ Washer H
Quick Disconnect Fitting
Water Hose
Hex Key Tool	(Included with Tool Kit)
PlasticTies
Wet Air Filter Canister		(Sold Seperately)
Water Kit Installation Procedure
Connect the Quick Disconnect Fitting				to the
single end of the Water Hose			.
Snap fit the Water Hose Outlets			to the Holes in the
Blade Guard . Orient the Water Hose				through the
Front Handle.

Loop the Hose Clamp Garound theWater Hose

and fasten the clamp to the Roller Bar Support Arm

using the Socket Head Cap Screw w/ Washer H, and

Hex Key Tool .

Use the PlasticTies as preferred to further secure the hose fittings and water hose to the saw.

When using the Water Kit option for your saw, the Dry Air Filter Canister MUST be replaced with the Wet Air Filter Canister (See Air Filter Kit Assembly in Parts Section of this manual).

Figure 11. Wet Air Filter Canister

SHS62A CUT-OFF SAW — OPERATION & PARTS MANUAL — REV. #0 (06/02/06) — PAGE 17