SHS62A CUT-OFF SAW — RULES FOR SAFE OPERATION
■NEVER leave the machine unattended while running.
■NEVER run the engine without the air filter. Severe engine damage could occur.
■NEVER wear jewelry or loose fitting clothing that may snag on the controls or moving parts, this can cause a serious injury.
■NEVER operate this saw without the blade guard, or other protective guards in place.
■NEVER stand behind or in front of the blade path while the engine is running.
■NEVER use abrasive blades that are less the 1/8" (3.17 mm) thick.
■NEVER exceed maximum blade speed shown for each blade size. Excessive speed could result in blade breakage.
■NEVER use a damaged saw or blades.
■NEVER try to stop a moving blade with your hand.
■NEVER use an abrasive blade that has been dropped.
■NEVER use carbide-tipped or toothed type blades of any kind.
■NEVER use segmented diamond blades unless they are specifically designed for
■NEVER place 1 inch (25.4 mm) arbor hole blades on 20 mm flanges.
■NEVER use the side of a
■NEVER cock, jam or wedge the blade in the cut.
■NEVER operate the saw if the blade does not stop rotating when the throttle trigger is released.
■NEVER start cutting until you have a clear work area and secure footing.
■NEVER allow other persons to be near the saw when starting, refueling, or when the saw is operating.
■NEVER allow bystanders or animals in the work area while using a
■NEVER touch a dry cutting diamond blade immediately after use. These blades require several minutes to cool after each cut.
■NEVER use damaged or worn blade flanges. Discard any damage or worn saw parts.
■NEVER allow blade exposure from the guard to be more than 180 degrees.
■NEVER operate this saw without both hands on the handles.
Diamond Blade Safety
■Use appropriate steel centered diamond blades manufactured for use on concrete saws.
WARNING
■ALWAYS inspect diamond blades before each use. The blade should exhibit no cracks,
dings, or flaws in the steel centered core and/or rim. Center (arbor) hole must be undamaged and true.
■Examine blade flanges for damage, excessive wear and cleanliness before mounting
blade. Blade should fit snugly on the shaft and against the inside/outside blade flanges.
■Ensure the blade is marked with an operating speed greater than the blade shaft speed of the saw.
■Only cut the material that is specified by the diamond blade. Read the specifications of the diamond blade to ensure the proper tool has been matched to the material being cut.
■ALWAYS keep blade guards in place. Exposure of the diamond blade must not exceed 180 degrees.
■Ensure that the diamond blade does not come into contact with the ground or surface during transportation. DO NOT drop the diamond blade on ground or surface.
■The engine governor is designed to permit maximum engine speed in a
■Ensure that the blade is mounted correctly for proper operation.
Saw Transportation Safety
■NEVER transport the saw with the blade mounted.
■ALWAYS use caution when lifting and transporting this saw.
■ALWAYS
■ALWAYS use caution and follow the instructions when loading and unloading the saw.
PAGE 10 — SHS62A
