Stow manual STR36SP-SERIES- Maintenance, Spare Drive Belt Replacement

STR36SP-SERIES— MAINTENANCE

5

6

4

2 1

3

1CV Joint

2Bolt (Remove 3 places)

3New Spare Drive Belt

4Bolt, Spare Drive Belt Carrier

5Spare Drive Belt Holder

6Left Side Gearbox

Figure 20. Spare Drive Belt Replacement

Spare Drive Belt Replacement

It will be necessary to disconnect the CV-Joint from the left-side gearbox

NOTE coupler. This means the removal of the three screws that secure the CV- Joint to the gearbox.

To replace a spare drive belt, be prepared to disconnect the CV- joint from the left-side gearbox. See Figure 20.

1.Place the trowel on suitable supports and observe all safety precautions.

2.Remove the three screws that secure the CV-joint to the left-side gearbox coupler.

3.Once the CV-joint has been separated from the left-side gearbox, push the CV-joint inward so that a gap exists between the gearbox and the CV-joint (Figure 20). Slide the spare V-belt between the gearbox coupler and the CV- joint. Avoid contaminating the replacement belt with grease or oil when sliding it between the CV-Joint and gearbox coupler.

4.Place the spare drive belt inside the drive belt carrier, and secure the spare belt carrier to the inboard side of the left gearbox.

5.Install the three screws that secure the CV-joint to the left- side gearbox coupler.

STR36SP- SERIES • RIDE-ON POWER TROWEL — OPERATION AND PARTS MANUAL — REV. #1 (09/16/11) — PAGE 29