Ice Machine Installation | 12 |
|
|
Panel Installation
DOOR PANEL INSTALLATION
You should be sure of the door panel size and placement before proceeding with the installation. Refer to the chart for panel specifications. If you have questions, contact your authorized
For door handle hardware, a
Remove the handle side bracket attached to the front of the door and set aside. Place the door panel lying face down on a protected surface to ensure that the front will not be scratched or damaged.
On the back of the panel, position the plastic template (provided) flush with the top and side edges. Be sure you are following the exact position for
Door Panel Specifications
Panel Width | 15" (381) |
Panel Height | 303/8" (772) |
Minimum Thickness | 5/8" (16) |
Maximum Weight | 15 lbs (7 kg) |
|
|
Dimensions based on 1/8" (3) reveal.
Panel dimensions in the chart are the minimum necessary to cover the door. The exact dimensions of your door panel may vary depending on your particular installation.
Once you have located the proper position for the hardware, mark the holes, remove template, and drill pilot holes for mounting the hardware. It is best to start the first few holes, position the hardware and then drill the remaining pilot holes. Secure the mounting brackets with #8 x 1/2" screws. Refer to the illustrations below.
Install the door panel by engaging the tabbed bracket to the door first and then sliding the hinge side hardware over the positioning screws. You will have a 1/4" (6) adjust- ment, up and down, and side to side.
Once you have the door in place, attach the remaining #8 x 1/2" screws to the hinge side mounting bracket and install the hinge covers. Refer to page 14.
Template position.
