Sub-Zero UC15IO manual Install The Ice Machine, Ice Machine Installation

Ice Machine Installation 9

Installation

INSTALL THE ICE MACHINE

1)Adjust the leveling legs close to the desired height. Refer to the illustration below.

2)Reverse the door swing if needed. Refer to steps outlined on the following pages.

3)Gravity drain models: Install the drain hose (provided) onto the drain fitting on the back of unit and route to the open site drain. Refer to the illustration below and plumbing requirements on pages 6–7.

Pump models: Route drain tubing through the drain fitting on the back of the unit and install the drain hose (provided) on the drain pump. Route the other end of the drain tubing to the drain site. Refer to the illustra- tion below and plumbing requirements on pages 6–7.

4)Use a compression fitting to connect the water inlet on back of ice machine to the prepared 1/4" (6) OD cold water line. Refer to the illustration below.

5)Open the shut-off valve on the water line. Check all plumbing connections for leaks. Failure to do so could result in flooding.

6)Plug the power cord into the grounded receptacle.

7)Level the ice machine to assure that the door closes and seals properly. Place a level on top of the unit and turn each leveling leg to raise or lower as needed.

subzero.com/specs

8)Move the ice machine into its final position.

9)Secure the ice machine by installing two #8 x 1/2" flat head screws through each hinge. Refer to the illustra- tion below.

10)Add 4 oz (115 ml) of undiluted ice machine cleaner to a container that will fit under the lifted water shutters. Refer to the illustration below for location of the water shuttters.

11)Press the CLEAN key pad. Wait three minutes until the CLEAN light flashes, then add the prepared sani- tizer by lifting the water shutters and pouring directly into the spray area. The ice machine will automatically time out a ten-minute sanitizing cycle, followed by eight rinse cycles, and stop. The CLEAN light will turn off to indicate that the sanitizing cycle is complete. This entire cycle lasts approximately 30 minutes.

12)Add one gallon (3.8 L) of cold water to a container that will easily fit under the lifted water shutters. Lift the water shutters and pour the water directly into the spray area. Watch for proper drainage.

13)Press the POWER button.

14)At initial start-up, the ice machine will need approxi- mately 30 minutes to freeze ice and up to five minutes to harvest the ice. Wait for first cycle of cubes to drop to ensure proper installation.

LEVELING

LEG

DRAIN FITTING

WATER INLET

HINGE

SCREWS

WATER

SHUTTERS

Leveling. Drain connection. Secure ice machine. Location of water shutters.