Subaru Robin Power Products EX30 manual PRE-OPERATION Checks, Electric Starter Models, Battery

3. PRE-OPERATION CHECKS

NOTE

Engine shipped from our factory is without oil. Before starting engine, fill with oil. Do not over-fill.

CHECK ENGINE OIL (See Fig. 2)

Before checking or refilling engine oil, be sure the engine is located on stable, level surface and stopped.

■Do not screw the oil gauge into the oil filler neck to check oil level. If the oil level is low, refill to the upper level with the following recommended oil.

■Use 4-stroke automotive detergent oil of API service class SE or higher grade.

■Select the viscosity based on the air temperature at the time of operation as shown in the table. (See Fig.2-q)

OIL CAPACITY : 1.0 liter

Explanation of Fig.2-w

q Oil Gauge

w Upper Level

e Lower Level

4. ELECTRIC STARTER MODELS

For electric starter operation, proper electric wiring arrangements are needed before normal engine operation.

1.BATTERY

■Use a battery rated 12V-24AH or larger.

WARNING

■Charge the battery in a fully ventilated location.

■Batteries generate hydrogen gas, which can be highly explosive. Do not smoke or allow flames or sparks near a battery, especially during charging.

■Be sure to confirm Battery polarity. Connect positive

(+)terminal first when mounting battery, and

disconnect negative (- ) terminal first when
	US
dismounting.
■ Battery electrolyte contains sulphuric acid. Protect	GB
your eyes, skin and clothing. In case of contact, flush	DE
thoroughly with water and get prompt medical
attention, especially if your eyes are affected.	FR
2. BATTERY CABLE	NL

■Use a proper cable and ground wire to connect battery. ES

■For GROUND WIRE, use a flat braided wire of 20 sq. IT

mm. or larger sectional area.						PT
						GR
6.5	6.5	EARTH (GROUND) WIRE				NO
CABLE
LA406	LA406					SE
			7
	25mm					FI
			Wire gauge			DK
						RU
Cable length	Cable dia.	AWG
					JIS CN
			(BS)	SAE
		BWG				AR
Less than 1.5m	7.3 mm		1	6	AV15
1.5 m to 2.5 m	8.4 mm		0	4	AV20
2.5 m to 4 m	10.8 mm		3/0	2	AV30

3. KEY SWITCH CABLE

If a remote key switch is used, select wires of proper gauge to connect it and magnetic switch of the engine.

			Wire gauge
Cable length	Cable dia.
		AWG		BWG	JIS
		(BS)
Less than 1.5 m	1.5 mm	14		16	AV1.25
1.5 m to 3 m	1.9 mm	12		14	AV2
3 m to 5 m	2.4 mm	10		13	AV3

5