Summit 225D6783P011 Cleaning the smart fill ice factory, Cleaning the cylinder, Removal of ice

20

note: It’s important that once you have completed the above steps you make sure that the water cylinder is correctly installed to prevent water freezing in the cylinder’s interior.

caution: Only fill with drinking water.

removal of ice

1. After a while, your ice cubes will be ready for use. To remove them, pull the handle slowly towards you until it’s fully down. At this point it will be necessary to pull the handle a little more forcefully until you hear the ice fall into the lower compartment of your Smart Fill Ice Factory.

2. This compartment can hold up 3 complete releases of the ice-tray. To remove the ice, simply lift and pull the storage box that you will find in the lower part. This box is designed to be brought wherever you wish. To make more ice, repeat the process.

note: The cylinder can only hold one load at a time. Before repeating the process, make sure that the tray is empty.

note: The ice produced may vary in size.

important: When removing the ice cubes, pull the handle all the way down. You will feel resis- tance at this point, but you need to pull a little more so that the ice-tray twists and releases the ice into the lower compartment. Once this point has been reached, the process is complete.

cleaning the smart fill ice factory

When cleaning your Smart Fill Ice Factory it is imperative that you only use a soft sponge with water and a neutral soap. Afterwards, leave it to dry.

DO NOT use a steel wool sponge or detergent to clean the SFIF (specially the ice-bucket), as this could affect how it works, change how it looks, and affect the flavour of your ice cubes.

cleaning the cylinder

Only use a soft sponge with water and a neutral soap to clean. Afterwards, leave it to dry. Don’t use steel wool sponges or detergents, knives or forks as these could scratch or damage the central valve. If there’s frozen water inside the cylinder, let it melt or use tepid water to speed up the process.