Summit 225D6783P011 manual Problem Probable Cause What to Do

33

frequently asked questions and operating guide

Problem	Probable Cause	What to Do
	Thecylinderhasn’tbeenpositionedcorrectly, and		Pour water into the cylinder again. Make sure that
			the cylinder has been positioned properly by
Smart Fill Ice	the ice-trays can´t be -lled with water.
			watching for water falling into the trays.
Factory won’t
	You aren’t giving it that extra pull to twist		Pull the handle more -rmly until completely
release ice
	the ice-tray.		twisting the tray.
	The ice-tray has an excess of scale.		Clean with a soft sponge.
	Water has spilt onto the lip area of the cylinder		Clean the ice accumulation with tepid water.
	or this has been -lled to excess. Ice has been
Smart Fill Ice	generated, impeding the opening of the lid.
Factory - It has
			Press the lid of the cylinder in the middle.
become dif￿cult	The lid of the cylinder has not been properly
			Remove ice residue, which may be near the valve,
to open water
	closed.		with tepid water.
cylinder lid
Smart Fill Ice	The valve was obstructed by ice.		Check that the tray doesn’t have ice stuck to it, or
Factory - When			that there isn’t an excess of water.
￿lling the cylinder,
water spills out
from the lower
part where the
valve is.
Ice-tray hasn´t	The programme has an in-built system to		Take out the cylinder and -ll it up to maximum
been ￿lled to	prevent over--lling and ice sticking.		capacity.
maximum
capacity
	The water cylinder wasn´t -lled up to the		Don’t add more water as this could spill out
			and/or could mean more force will be required to
	maximum level.
			release the ice cubes.
	The refrigerator is resting on a sloped ‚oor,
Ice cubes	and/or it itself is inclined. Thus, some ice-tray
	cubes might not get fully -lled. (The water		The variation in size of ice cubes is normal.
vary in size
	cylinder has the exact volume space for
	water as the ice-tray.)
	The refrigerator must have a certain incline
	backwards. This may cause the ice-tray to lie
	slightly unevenly.
Smart Station	Freezer duct or grille obstructed.		Check that there aren’t any objects or foods
			obstructing the air-way in the freezer´s air ‚ow
isn’t chilling
			grille (grille at the front of the compartment).
	It has been installed in an unsuitable place.		See the installation instructions.
Unusual Noises
	The levelling is not adequate.		Adjust the levelling knobs.
	The accessories are not well positioned.		Adapt them in accordance with instructions.
	It has been installed in an unsuitable place.		See installation instructions.
	The air circulation is obstructed.		Don’t allow air outlets to be obstructed.
Refrigerator is	Door is being left open for excessive amounts of time.		Only open refrigerator doors for necessary time.
not cooling items	The knob on the exterior temperature display		See operating and user guide.
	has been incorrectly set.
	Refrigerator is exposed to direct heat or sunlight.		See installation instructions.
External	Elevated humidity in the atmosphere		It is normal for atmospheric humidity to be higher
Condensation	(higher than 75 % RH).		than 75%.
External	The access door is not being closed properly.		Check that there aren’t any objects inside the
condensation on
			access door keeping it from closing.
exterior door
(depending on	On high temperature and high humidity		This is a normal condition in the performance
model)	enviroments your refrigerator may show		of the unit. Sweep it with a dry cloth
	condensation on the acces door.		whenerver you feel it is needed.