Summit 225D6783P011 manual Smart fill ice factory, Starting up

19

In case of a spillage, you can take the following steps to easily clean the exterior door:

To remove and replace the exterior door of your Smart

Station you will need a small screwdriver:

1.Open the exterior access door

2.Use the flat part of the screwdriver to remove

the door from the base on the left hand side.

3. Find the hinge and screw the screwdriver into it.

4. Once you have unscrewed the hinge, pull the door to the right until it comes away.

5. To replace the door, first attach it to the bolt on the right-hand side.

6. Slide the edge to the right using the screwdriver, and align it with the marked groove.

7. Use light movements until you hear a click indicating that the door is properly positioned.

smart fill ice factory

(only available with certain models)

This no-spill ice-maker with removable cylinder feeds directly into the ice-tray. It comes with a storage box that can hold up to 900g of ice.

starting up:

Remove the water cylinder found at the top of the Smart Fill Ice Factory (SFIF) by pulling the top middle part towards you.

Once removed, place the water cylinder on a flat surface. Open the top, which you’ll find in the middle centre. To avoid spillages, make sure that there’s no residual ice obstructing the valve of the cylinder before you fill it with water. Pour 180 ml of purified water into the cylinder or fill it to the maximum level.

Replace the top, placing pressure on the middle. It’s essential that it’s secure in the centre in order to avoid water leaking out.

Put the cylinder back in its original position making sure it’s securely connected. You should be able to see and hear the water filling the ice-tray which indicates that the cylinder is correctly installed.