Sunbeam 400 Using your Sunbeam Oskar, Before using your Oskar, Horizontal, Large locking tab

Using your Sunbeam Oskar 400.

Before using your Oskar 400

•Wash the processing bowl, cover, continuous flow attachment and all attachments in warm to hot water using a mild detergent. Dry each part thoroughly before use.

•Before you assemble the Oskar 400, ensure that the power cord in unplugged.

4.Place food in the food processor bowl.

5.Place the processing bowl cover on the processing bowl so that the large locking tab on the cover is to the right side of the bowl, near the horizontal slot at the back of the processing body (3).

Using the processing bowl and cover

1.Set up the motor base facing you on a dry, level surface.

Note: The tallest side of the motor housing to the rear.

2.Place the processing bowl over the drive shaft and rotate the container until it drops down evenly onto the base. Turn the processing bowl anti-clockwise firmly until it ‘locks’ into place (1).

	Horizontal
Large locking tab	slot	(3)

(1)

3.Fit the processing blade onto the drive shaft, rotating it slightly until it settles into place (2).

(2)

6.Plug in the food processor and turn the power ‘ON”.

7.Turn the processing cover to the left (anti- clockwise), this will engage the automatic switch and the food processor will turn on (4).

(4)

Note: Unless the locking tab on the processing bowl cover is engaged, the unit will not turn on.

6