Sunbeam 4041, 4043, 4042 user manual Maintenance

maintenance

2.Fill the water reservoir with tap water to the “MAX” line.

3. Set the Fabric Select Dial to LINEN.

4.Plug the iron into a power outlet and allow

the iron to heat for 2 minutes.

5. Turn the Fabric Select Dial to MIN and unplug the iron.

6.Hold the iron over a sink in a horizontal

position.

WARNING: Be careful not to touch the iron’s hot surfaces.

7.Press the self-clean button and hold. Water will begin dripping from the steam vents. To make sure that all of the water is removed from the

tank, slowly rock the iron side to side and front to back for 30 seconds. When rocking the iron, dip the nose of the iron slightly below the rear of the iron to make certain the water circulates completely. Release self-clean button after

one minute.

12