Sunbeam 4141 Assembling Your Blender, Assembly Of Container, Tightening The Container

ASSEMBLING YOUR BLENDER

CAUTION: Follow these important steps to assemble, tighten, and mount Blender container quickly and correctly. INJURY MAY RESULT IF MOVING BLADES ARE ACCIENTALLY EXPOSED.

ASSEMBLY OF CONTAINER

Turn container upside down so the small opening is at the top. Place sealing ring on container opening. Turn the agitator blades upside down and place in mouth of container. Thread container bottom to container. Engage threads properly. Screw on firmly.

TIGHTENING THE CONTAINER

To tighten container bottom, put assembled container securely into motor base ring with handle and lug in front of the right stop. Using container handle, turn container

to the left as far as possible. This insures that the container bottom is tightened properly. Remove container from motor base and mount.

OPERATING YOUR SUNBEAM® BLENDER

To operate Blender, place assembled container in motor base ring with container lug against flat side of the motor base stop. If container lug does not rest flat side of right stop, remove container assembly and place against flat side of left stop. Seat container firmly and operate. To remove container, lift straight up. (If it does not easily remove, rock gently and lift up, do not twist.) Do not attempt to place the container on, or remove from the motor base while the motor is running.

CARE AND CLEANING OF YOUR SUNBEAM¨ EASY-CLEAN BLENDER

Blender container parts are corrosion resistant, sanitary and easily cleaned. Before first use and after every use, separate container parts and clean thoroughly in warm, soapy water, then rinse and dry well. DO NOT WASH ANY PARTS IN AN AUTOMATIC DISHWASHER, EXCEPT BLENDER JAR. Periodically check all parts before re-assembly.

If the processing blades are stuck or difficult to turn, DO NOT USE BLENDER. Check by carefully turning the blades in a counter-clockwise direction (opposite edges are sharp). Blades should turn freely.

If the container is chipped or cracked, DO NOT USE BLENDER. Further use could result in the container breaking during use.

Use only Sunbeam recommended replacement parts available at an Authorized Service Facility or the factory.

USE OF DAMAGED OR NON-RECOMMENDED PARTS COULD RESULT IN A SEVERE PERSONAL INJURY AND/OR DAMAGE TO THE BLENDER. NEVER IMMERSE THE MOTOR BASE IN WATER. The housing can be cleaned with a damp cloth (unplug first).

The motor is permanently lubricated and does not require any additional lubrication.

ANY SERVICING SHOULD BE PERFORMED BY AN AUTHORIZED SERVICE FACILITY. Call toll-free number listed in this manual for list of Authorized Service Stations.

5