SunBriteTV SB5560HDBL manual TV Installation - Rear Panel Connections, Switching Sources for Ports

TV Installation – Rear Panel Connections

Switching Sources for Ports:

Model 5560HD offers several options when connecting your devices to the TV. The chart below will help you understand which source you switch to for each of the ports.

CONNECTING TO AN ANTENNA

Connecting to Digital Cable without Cable Box or Antenna

1.Make sure the power to the TV is turned off.

2.Connect the Coaxial RF cable from your antenna or digital cable to the ATSC/NTSC port off the back of the TV.

3.Turn on the TV.

4.Select TV (Air) for antenna or TV (Cable) for digital cable from either your remote control’s source button or source button on the right side of the TV.

5.Use the On-Screen Display to scan for channels.

Please Note :

Connecting to Cable or Antenna

1.Make sure the power of the TV is turned off.

2.Connect the Coaxial RF cable from your antenna or cable to the

ATSC/NTSC port off the back of the TV.

3.Turn on the TV.

4.Select TV (Air) for antenna or TV (Cable) for cable from either your remote control’s source button or source button on the right side of the TV.

5.Use the On Screen Display to scan for channels.

1.Not all broadcasts are in High Definition (HD). Please refer to your local broadcasting stations for more information.

2.The TV’s tuner is designed for HDTV therefore requires a stronger signal than normal TVs. If you cannot achieve that signal level with your antenna or cable, the TV might lose picture or sound.

SunBriteTV Model SB-5560HD Operator’s Manual Page 11