SunBriteTV SB-5560HD-BL manual IR Emitter Installation, TV Installation - Rear Panel Connections

TV Installation – Rear Panel Connections

CONNECTING TO A PC (Continued)

Connecting with VGA Analog (Good)

1.Make sure the power of the TV and your PC is turned off.

2.Obtain a 15-pin D-Sub VGA cable, connect to the VGA output of your PC and the other end to the VGA port off the back of your TV.

3.Obtain a 3.5 mm Mini-jack, connect to the audio out of your PC and the other end to the VGA Stereo Input port.

4.Turn on the power of the TV and your PC.

5.Use the remote control’s source button or the source button the TV to switch to VGA.

Please Note :

1.For the best results, please set your PC resolution to

2.1920 x 1080at 60 Hz. Refer to the PC or graphic card’s manual for further instructions on how to set your resolution and refresh rate.

3.Refer to your PC manual for video output requirements of the video card.

4.The VGA port of the TV features a power saving mode which will automatically turn off the TV if there is no signal provided for more than 15 minutes.

IR Emitter Installation

To install the IR Emitter:

The photo to the right shows an IR Emitter* installed.

The end of the Emitter is to be mounted in front of the IR Emitter Window.

Place the emitter on the white tie-down block and use the tie-down to secure it in place.

Place the emitter cable over the right or left side of the cable box and connect the other end of the emitter to the appropriate control block*.

*Neither the emitter or control block are supplied by SunBriteTV. See instructions that come with your IR Emitter and control block to determine how to make the connections.

IR Window Tie-Down

Tie-Down Block	IR Emitter	Place IR Emitter Cable
		over right or left side of
		the cable box.

SunBriteTV Model SB-5560HD Operator’s Manual Page 17