SunBriteTV SB-5560HD-SL manual TV Installation - Rear Panel Internal Connect Source, Thumb Screws

TV Installation – Rear Panel Internal Connect Source

Rear Panel Connections

WARNING: Do not connect the power source before making connections.

Internal Connect Source

The Internal Connect Source allows you to easily connect to the Audio, Video, S-Video, SVGA, HDMI, Audio Out, RF, RS232, and 12 VDC connectors, and the IR emitter window. The Internal Connect Source is inside the Cable Cover located on the back of the unit (Figure 1).

1.Unscrew the three gray Thumb Screws (Figure 1), and pull the cover towards you.

2.Route the cables to the proper inputs, and place the cable cords over the Rubber Sealing Gasket (Figure 2).

Note: There is an Indentation on the Rubber Sealing Gasket (on the bottom portion of the right and left sides). Make sure cable cords are not placed on the Indentation.

3.Close the cover (Figure 3).

4.Press firmly on the cover, and secure the Thumb Screws tightly (Figure 4).

	Figure 2	Cables are to be placed over
Figure 1		the Rubber Sealing Gasket

	Thumb Screws	Cables are not to be placed
		over the indentations
Figure 3		Figure 4

Press firmly on the cover, and secure the Thumb

Screws tightly.

Page 8