Sunrise Medical 600 SERIES, 500 SERIES To Find & Correct a Problem, Breezy 600 Series

X . S E T U P & A D J U S T M E N T

2. Torque Wrench

If you plan to adjust and maintain this chair yourself, Sunrise recommends that you use a torque wrench.

Note: A torque setting is the optimum tightening which should be made on a particular fastener.

Atorque wrench which measures in.-lbs. should be used when tightening fasteners on Breezy wheelchairs. Unless otherwise noted, use a torque setting of 50-65 in./lbs. (5.6-7.3 N.m) when setting- up this wheelchair.

When properly set up, your chair will roll smoothly and easily. All components should also work smoothly. If you detect a problem, be sure to correct it before using this chair.

C.TO FIND & CORRECT A PROBLEM

1.Review the TROUBLESHOOTING section to see if your chair has one of the listed symptoms. If so, follow steps to solve the problem.

2.Follow steps in this section to make sure set up is correct.

3.If steps 1 and 2 do not work, consult your authorized supplier for help.

4.If you still have a problem, contact customer service at 800.456.8165.

D. ANTI-TIP TUBES (Optional)

Anti-tip tubes are recommended unless you are a skilled rider of this chair and are sure you are not at risk to tip over.

The following is recommended for all Breezy models except the 600 (listed next):

Note: When locked in place, anti-tip tube wheels should be between 11/2” to 2” (38 mm to 51 mm) off the ground. If set too high, they may not prevent a tip over. If set too low, they may “hang-up” and cause a fall or tip over.

X . S E T U P & A D J U S T M E N T

1.To Install

a. Depress button (1) to draw second

button (not shown) inside anti-tip	1	4
tube (3).	3
b. Insert tube (3) into frame (4).
Release button.

c.Rotate tube (3) until button (2) locks in place in mounting hole (not shown).

2. To Turn Anti-Tip Tube Up

a.Depress button (1) to draw second button (not shown) inside anti-tip tube (3).

b.Hold button in and turn anti-tip tube

up. Release button.

c. Repeat with other side.
3. To Adjust Wheel Height
a.	Depress button (6).
b.	Raise or lower wheel tube (7) to	7	6
	one of three predrilled holes and
	lock it in place.

c.Raise or lower wheel tube (7) to one of three predrilled holes and lock it in place.

Note: You may need to use a longer or shorter wheel tube section to attain correct height of

1 1/2” to 2” (38 mm to 51 mm). You can obtain these from your authorized supplier.

BREEZY 600 SERIES

1.Inserting Anti-Tip Tubes Into Receiver

a.Press the rear anti-tip release lever on the anti-tip tube so that both release pins are drawn inside.

b.Insert into the anti-tip tube receiver.

c.Turn the anti-tip tube down until release pin is through the receiver mounting hole.

d.Insert second anti-tip tube the same way.

930300 Rev. C 34 35 930300 Rev. C