Sunrise Medical 600 SERIES, 500 SERIES FLIP-BACK Armrests, FLIP-BACK Height Adjustable

X . S E T U P & A D J U S T M E N T

X . S E T U P & A D J U S T M E N T

2.Axle Positioning (Threaded or Offset)

a.When the axle is placed in the lower axle position, the caster should also be placed in the lower caster fork position.

b.When the axle is placed in the top axle position, the caster should also be placed in the top caster fork position (except when using pneumatic rear tires - pneumatic rear tires are always placed in the top axle position).

H. REAR WHEEL LOCKS

The Breezy Series wheelchairs come with wheel locks.We install wheel locks at the factory unless you request otherwise.

Note: Use a torque setting of 25-40 in./lbs. (2.8-4.5 N.m) to tighten wheel lock bolts.

Make sure lock arms embed in tires at least

1/8” (3 mm) when locked. If you fail to do so, the locks may not keep the rear wheels from rolling.

2

1 3

2.Wheel Locks - Quickie Style (Option) Quickie style high-mount wheel locks are installed at Sunrise unless you have

requested otherwise.

Note: Use a torque setting of 70-80 in./lbs.

(7.9-9.0 N.m) to tighten when setting up wheel locks.

To install or adjust high-mount wheel lock:

a.Loosen the screws on the top of each clamp. Do not attempt to remove one screw at a time.

b.Slide assembly toward rear wheel, until clamp embeds into tire, to prevent wheel movement when in locked position.

I.FLIP-BACK ARMRESTS

Note: Non-removable; we install this armrest at

the factory.

J. FLIP-BACK HEIGHT ADJUSTABLE

ARMRESTS (Optional)

Note: Armrest is removable; you can adjust the

height of the armrest pad.

1.High-Mount Wheel Locks (push-to-lock or pull-to-lock)

To install or adjust:

a.Use a open-end wrench to loosen two bolts (1) on top clamp (2).

b.Turn each bolt counter-clockwise one- quarter turn; then loosen each bolt two turns until you can remove both bolts. (Alternate, to keep bolts from binding.)

c.Side clamp (2) toward rear wheel until lock arm (3) embeds in tire at least 1/8” (3 mm) when locked.

d.Alternate as you retighten bolts (1).

e.Repeat steps on other side.

1. To Flip Armrest Back

Push latch lever (1) toward tube to “flip” or “tilt” armrest back.

2.Installation

a.Tilt armrest back and insert rear arm tube (2) into receiver (3).

b.Tilt armrest forward.This will engage pin to secure rear arm tube.

c.Push armrest down until front tube locks in place.

3.Removal

a.Push latch lever (1) toward tube.

b.Tilt armrest back toward rear of chair.

c. Pull up on armrest (pin holding arm- rest in rear tube will release).

4. Height Adjustment

a. Pull back on upper lever (4) to release.

b.Slide armrest up or down to chosen height.

c. Release upper lever (4). Move armrest	2
slightly to make sure it locks in place.
4	3
1

930300 Rev. C 38 39 930300 Rev. C