X . S E T U P & A D J U S T M E N T

X . S E T U P & A D J U S T M E N T

3. Turning Anti-Tip Tubes Up

Turn anti-tip tubes up when being pushed by attendant, overcoming obstacles or climbing curbs.

a.Press the rear anti-tip tube release lever.

b.Hold lever in and turn anti-tip tube up.

c.Release lever.

d.Repeat with second anti-tip tube.

e.Remember to return anti-tip tubes to down position after completing maneuver.

E.STANDARD & LOW FRONT SEAT HEIGHTS

Note: Adjust seat height for body and mechanical efficiency. Be aware that a change in seat height may require a change in the size of the front caster stems or forks.

1. If you raise the seat too high, you may “out-adjust” the caster forks. If this occurs, the seat will tilt toward the front and may cause the rider to fall.

2.To avoid this, you will need to use a longer caster fork or fork stem.

1.Adjustment

a.For a standard 18 1/2” (470 mm) front seat height:

1.Remove the axle bolt.

2.Set axle in the bottom frame setting. Re-attach axle bolt and tighten.

3.Repeat steps on other side. Make sure both sides are the same height.

b.For a low 17 1/2” (445 mm) front seat height:

1.Remove the axle bolt.

2.Set axle in the top frame setting. Re- attach axle bolt and tighten.

3.Repeat steps on other side. Make sure both sides are the same height.

Note: Use a torque setting of 150 to 175 in./lbs. (16.9-19.8 N.m) for axle nuts.

2.Seat Angle (not available on BREEZY 500) If you change the seat height, make sure you adjust the front casters to attain the proper seat angle. (The seat should be slightly higher at the front.)

F. CASTER FORKS

Note: Two-hole caster forks allow you to adjust

the seat height or seat angle.

a.For a standard 18 1/2” (470 mm) front seat height:

1.Remove caster wheel bolt (1) and bearing spacers (not shown).

2.Move caster into the bottom fork position (2).

3.Replace caster wheel bolt and bearing spacers.Tighten bolt.

4.Repeat steps on other side. Make sure to adjust both the same.

b.For a low 17 1/2” (445 mm) front seat height:

1.Remove caster wheel bolt and bearing spacers (1).

2.Move caster into the top fork position (3).

3.Replace caster wheel bolt and bearing spacers.Tighten bolt.

4.Repeat steps on other side. Make sure to adjust both the same.

G. REAR WHEELS - THREADED OR FIXED OFFSET AXLES

(BREEZY 510)

Note: Use a torque setting of 150-175 in./lbs. (16.9-19.8 N.m) when setting-up axles.

1.Installation

a.Remove threaded axles, axle bolts and hub caps from plastic bag.

b.Remove inside bolt from axle and insert the axle through one of two holes in the rear frame tube.

c.The hole you choose affects the rear seat height place the axle in the lower hole for level seating; place the axle in the upper hole for lower rear seat height.

31

2

930300 Rev. C

36

37

930300 Rev. C

Page 19
Image 19
Sunrise Medical 500 SERIES Standard & LOW Front Seat Heights, Caster Forks, Rear Wheels Threaded or Fixed Offset Axles