A s s e m b l y o f B a t h B a s e K i t
7
Make sure
16.Once the bubble is in the center of the
Red zone must not be visible for the post to be safely secure.
Do not
17.Remove the level from the post by sliding it up off the bottom portion of the post. Slide the blue locking handle down to fit into the bottom part of the post to lock the post in place (Figure 14).
NOTE– Once the blue locking handle is pressed into the bottom portion of the post, the post can be turned as a whole, except the top and foot plate. This will not lower the post. The post must turn to enable you to attach the rail.
18.Place the rail onto the pins of the bath post (Figure 15). Refer to the drawing to find out which set of pins to use to hang the rail.
a.For the
b.For
19.Place one round blue cap on the top of the post (Figure 18).
20.Slide the blue plastic strips into the slides of the posts by pinching the strip on each side to press it into the grooves. Start at the bottom of the posts (Figure 19).
Figure 13-A
Figure 14
Figure 16
Figure 18
Figure 13-B
Figure 15
Figure 17
Figure 19
Bath Base Kit