Sunrise Medical M6 I I . W a r n i n g s C o m p o n e n t s & O p t i o n s, Upholstery Fabric

24 V I I I . W a r n i n g s : C o m p o n e n t s & O p t i o n s

M. UPHOLSTERY FABRIC

1. Replace worn or torn fabric of seat and seat back as soon as you can. If you fail

to do so, the seat or seat back may fail.

2. Sling fabric will weaken with age and use. Look for fraying, thin spots, or

I X . C h a i r B a s i c s 25

A. TO MOUNT & REMOVE REAR WHEELS

Do not use this chair UNLESS you are sure both quick-release axles are locked. An unlocked axle may come off during use and cause a fall.

stretching of fabrics especially at edges and seams.

3. “Dropping down” into your chair will weaken fabric and result in the need to

inspect and replace the seat more often.

4. Be aware that laundering or excess moisture will reduce flame retardation of

the fabric.

If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of control may occur and cause severe injury to the rider or others.

NOTE– Axle is not locked until:

a.The quick-release button pops out fully. (Fig. 1)

b.The ball bearings are fully visible on the outside of the sleeve.

1.To Install Wheel (Figs. 1 & 2):

a.Depress quick-release button (1) fully. This will release tension on ball bearings at other end.

b.Insert axle through hub of rear wheel.

c.Keep pressure on button (1) as you slide axle (2) into axle sleeve (3).

d.Release button to lock axle in sleeve. Adjust axle if it does not lock.

e.Repeat steps on other side.

2.To Remove Wheel:

a.Depress quick-release button (1) fully.

b.Remove wheel by sliding axle (2) out of axle sleeve (3).

c.Repeat steps on other side.

1. Quick-Release Button

Figure 1

3. Axle Sleeve

2. Axle

Figure 2

930457 Rev. A 930457 Rev. A