I X . S E T - U P , A D J U S T M E N T & U S E
I X . S E T - U P , A D J U S T M E N T & U S E
N. PARAPAK SEAT SLING (SEAT FRAME ONLY)
The seat sling tension can be adjusted through use of the VELCRO® retaining material beneath the seat.
1.Adjustment
a)Remove the screws retaining the left side seat sling.
b)Readjust VELCRO® style material to increase the tension in the seat sling.
c)Replace screws and tighten.
Important Note: If there is any difficulty in re-
attaching the screws, try using a probe to help
line up the holes.
O. SEAT HEIGHT AND ANGLE ADJUSTMENT
Adjusting the seat height can be done both at the front and at the rear of the seat. Seat angle can also be varied through front and rear seat height adjustment.
1.Rear Seat Height Adjustment
a)Use positioning holes (A & B) and receiver notch (C).
2.Front Seat Height Adjustment
a)Use positioning holes (I, II, i, ii) and hole set (1).
P. WHEEL LOCKS
Wheel locks are installed by Sunrise when requested on the Quickie
1.Mounting
The wheel lock mounts to the
a)Loosen bolt (D).
b)Slide mounting bracket toward rear wheel until clamp embeds into tire to prevent wheel movement when in locked position.
c)Tighten screw.
C B
A
I
II
1 | ii i |
D 
F
Note: Brake shown in rear position.
Hole F is used on standard position
Q.CHECK-OUT
Once the wheelchair is assembled and adjusted, it should roll smoothly and easily. All accessories should also perform smoothly.
After the wheelchair has been set up be sure the chair performs to your speci- fied operational settings (see pages
Repeat this procedure until the wheelchair performs to specifications before attempting active use of the wheelchair.
If you have any problems, follow these procedures:
1.Review the
2.If your problem persists, contact your authorized supplier. If you still have a problem after contacting your authorized supplier, contact Sunrise customer service. See the introduction page for details on how to contact your authorized supplier or Sunrise customer service.
930486 Rev. A | 36 | 37 | 930486 Rev. A |
