Setting the Loop Mode
The Wireless Receiver has a built in Loop Mode that will display cycle between all active channels every few seconds.
To turn Loop Mode on, move the ’L’ or Loop switch down to the ON position. The Receiver will automatically switch between active channels every few seconds.
When the Loop switch is ON the LED indicator on the front of the Receiver will flash RED on the current active channel.
|
|
|
|
|
|
|
|
|
|
| In this diagram Loop has been turned |
|
|
|
|
|
|
|
|
|
|
| on as well as Channels 1 and 4. The |
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
| Receiver will cycle from Channel 1 to |
1 | 2 3 |
| 4 L | Channel 4 every few seconds. | |||||||
ON
Camera Placement & Interference
The Wireless OutdoorCam operates on 2.4GHz frequency. Some devices such as wireless routers, microwaves, cordless phones can cause interference and affect picture quality as they use the same frequency. If you are experiencing interference or poor image quality try the following steps:
-move or orient the camera in a different location
-adjust or aim the receiver antenna
-limit the number of walls, floors between the camera and receiver as this can dramatically alter picture quality
-dense materials such as concrete or metal will impede the wireless signal; move the camera and/or receiver away from dense materials
-if possible keep the camera and receiver away from or move conflicting devices such as wireless routers, microwaves, cordless phones
-make sure all cameras are set to different camera channels
-disconnect all other wireless devices to find out which is causing the problem and adjust your setup accordingly
-analog wireless cameras are not recommended for use with DVR systems; if you are looking for a wireless camera solution for recording purposes see the digital wireless
-some wireless signals may originate from nearby homes or businesses; in this case a wired camera may be necessary
9
