5.15 Motion Set
MOTION SET |
|
MOTION RECORD TIME: | 10 |
MOTION ALARM TIME: | OFF |
MOTION SET
(UP，DOWN) MOVE (SELECT) CHANGE
PRESS (MENU) TO EXIT
MOTION SET:
User Manual
MOTION RECORD TIME:
This number indicates how many seconds the motion detection recording lasts after the DVR has detected motion.
MOTION ALARM TIME:
This number indicates how many seconds the buzzer/alarm inside the DVR will sound after the DVR has detected motion.
CONT: Continuous alarm until press any key is pressed when motion detected.
OFF: No alarm
MOTION DETECTION SET
>CHANNEL 1 SENSITIVITY 4 CHANNEL 2 SENSITIVITY 4 CHANNEL 3 SENSITIVITY 4 CHANNEL 4 SENSITIVITY 4
CHANNEL 1 AREA SET
CHANNEL 2 AREA SET
CHANNEL 3 AREA SET
CHANNEL 4 AREA SET
(UP，DOWN) MOVE (SELECT) CHANGE
PRESS (MENU) TO EXIT
AREA SET:
SENSITIVITY:
Use [
Up] and [ Down] button to highlight the channel you want to modify and press [
SEL] to adjust sensitivity of motion detection on each channel.
High | 9, OFF) Low |
When “OFF”, the channel will not
detect motion or trigger motion recording.
Use [
Up] and [ Down] button to select the channel you want to modify and press [
SEL] button to enter the sensitive area of each camera. The picture of the selected channel is divided into 16(4*4) blocks, press [REW] to move left, press [FWD] to move right, press[
Up] and [ Down] to move the cursor up and down, press [
SEL] to set the highlighted block active or disabled.
When the block is transparent, it’s active or set to detect motion. When the block is covered by a shadow, it is not active and motion will NOT be detected.
Make sure Record Schedule is set to Motion for the times required.
5.16 Video Mode
Select NTSC (North America) or PAL (Europe/Australia) video system.
- 11 -
