|
|
|
| User Manual |
5.14 Motion Set |
|
| MOTION RECORD TIME: | |
|
|
| ||
|
|
| This number indicates how many | |
|
|
| seconds the motion detection recording | |
MOTION SET |
| lasts after the DVR has detected motion. | ||
MOTION RECORD TIME: | 10 |
|
| |
MOTION ALARM TIME: | OFF | MOTION ALARM TIME: | ||
MOTION SET |
|
| This number indicates how many | |
|
| seconds the buzzer/alarm inside the DVR | ||
|
|
| ||
PRESS (UP, DOWN), | ENTER | will sound after the DVR has detected | ||
(SELECT) |
|
| motion. | |
PRESS (MENU) TO | EXIT |
| ||
CONT: Continuous alarm until press any key is pressed when motion detected.
OFF: No alarm
MOTION SET:
MOTION DETECTION SET
>CHANNEL 1 SENSITIVITY 4 CHANNEL 2 SENSITIVITY 4 CHANNEL 3 SENSITIVITY 4 CHANNEL 4 SENSITIVITY 4
CHANNEL 1 AREA SET
CHANNEL 2 AREA SET
CHANNEL 3 AREA SET
CHANNEL 4 AREA SET
PRESS (UP, DOWN), ENTER
(SELECT)
PRESS (MENU) TO EXIT
AREA SET:
SENSITIVITY:
Use [
Up] and [ Down] button to highlight the channel you want to modify and press [
SEL] to adjust sensitivity of motion detection on each channel.
High | 9, OFF) Low |
When “OFF”, the channel will not
detect motion or trigger motion recording.
Use [
Up] and [ Down] button to select the channel you want to modify and press [
SEL] button to enter the sensitive area of each camera. The picture of the selected channel is divided into 144(12*12) blocks, press [REW] to move left, press [FWD] to move right, press[
Up] and [ Down] to move the cursor up and down, press [
SEL] to set the highlighted block active or disabled.
When the block is transparent, it’s active or set to detect motion. When the block is covered by a shadow, it is not active and motion will NOT be detected.
Make sure Record Schedule is set to Motion for the times required.
- 11 -
