LEVEL GROUND
1 | Clear out and level the ground in the location where | ||||
your deck is to be installed. |
|
| |||
| Use the following chart for the area size: | ||||
|
|
|
|
|
|
|
| SIZE | A | B |
|
|
| 12 x 18 | 8 ft. | 6 ft. |
|
|
| 12 x 24 | 12 ft. | 6 ft. |
|
|
| 15 x 24 | 12 ft. | 6 ft. |
|
|
| 15 x 30 | 16 ft. | 6 ft. |
|
|
| 18 x 33 | 16 ft. | 6 ft. |
|
|
| 18 x 45 | 28 ft. | 6 ft. |
|
A
DECK B
POOL
2 ASSEMBLE FENCE POST BRACKETS ON DECK SIDE
If your pool is filled with water it will be necessary for you to lower the water level to 2’ deep in order to assemble the Fence Post Brackets to the pool.
Before assembling your pool, take the Verticals or Buttress Posts, for the straight side of the pool where the deck is to be assembled and attach two Fence Post Brackets to each using the 1/4 x 20 x 3/4” screws, washers and hex nuts provided as shown at the bottom.
If the vertical or Buttress post do not have |
|
| ||
| ||||
simply measure down the required distance from the top and |
|
| ||
place the bracket on the post or vertical as shown. |
| 3” | ||
Use a distance of | FENCE POST |
|
| |
a distance of 3” for the Vertical. |
|
| ||
BRACKETS | ||||
Then using the Post Bracket as a template drill through (2 Pieces) the Vertical or Buttress post using a 5/16” drill bit.
HEX
NUT
WASHER
1/4" TRUSS
VERTICAL
These Locations on theHEAD SCREW 30 x 15 Pool
|
|
|
|
|
|
FENCE POST | 2- | 3/8” | |||
|
|
| |||
|
|
| |||
BRACKETS |
|
| HEX | ||
(2 Pieces) |
|
| NUT | ||
|
|
|
|
| WASHER |
|
|
| |||
|
|
|
|
|
|
1/4" TRUSS
HEAD SCREW BUTTRESS POST
4
