Manuals / Swim'n Play / Lawn and Garden / Swimming Pool

Swim'n Play side deck manual Position Your First Deck Section, CLOSE-UP #3, CLOSE-UP #1

Models: side deck

1 16

Page 5

3 POSITION YOUR FIRST DECK SECTION

Starting at the ﬁrst or last (left or right) vertical of the straight side of the pool, place the Ledge section of a 4’x5’ patio over the two top plates as shown Close Up #1.

Attach two long posts to the back side of the deck using the 2” screws and hex nuts as shown in Close Up #3.

Only hand tighten the screws at this time.

If your deck has only one 4’x5’ patio as on the 18x12 Side deck, proceed to step 5 now.

HEX

NUTS

2” SCREWS

CLOSE-UP #3

LONG POST

CLOSE-UP #1

Start Here

or Here

Page 5

Image 5

Swim'n Play side deck manual Position Your First Deck Section, CLOSE-UP #3, CLOSE-UP #1

Contents

SIDE DECKS ASSEMBLY INSTRUCTIONSDANGER ADULT SUPERVISION REQUIREDGENERAL CONTRACT INSTALLATIONSLOCAL CODES BARRIER REQUIREMENTSASSEMBLY DRAWINGS Use the drawings below for reference while assembling your deckSIZE LEVEL GROUND2 ASSEMBLE FENCE POST BRACKETS ON DECK SIDE CLOSE-UP #1 3 POSITION YOUR FIRST DECK SECTIONCLOSE-UP #3 CLOSE-UP #3 4 POSITION THE REMAINING 4’X5’ PATIOSASSEMBLED DECK DRAWING POSITION THE 18”X 5’ LEFT AND RIGHT PATIOSCLOSE UP #2b CLOSE UP #2aBOTTOM SUPPORT CHANNELS ATTACH THE LADDER POSTCLOSE UP #10 7b ATTACH BOTTOM SUPPORT CHANNELS ANGLE SUPPORT BARCLOSE UP #11 CLOSE UP #12CLOSE UP #12 ANGLE SUPPORT BARS TO DECKCLOSE UP #11 9 3” SPECIAL POSTS /CHECK YOUR WORK AND TIGHTEN 10 DECK LEDGESGENERAL ASSEMBLY ILLUSTRATION Before assembling your pool, drill the Fence Posts as described on the following pages Ruber Cap STANDARD POST FENCE BRAKET INSERTED THROUGH POST1/2 Sheet Metal Screw VIEWED FROM OUTSIDE OF POOLMETAL SCREWWARNING LABELS WARNING Make sure that your pool is not accessible when not in use