Swisher E4-S3000 manual Specifications E4-$3000, Prior to Assembly

Product	Description
		E4-$3000 TRIMMER	Using the accompanying illustrations as
		Throttle Interlock	a guide,	familiarize		yourself	with	this unit
			and its various		components.		See	Figure	4.
	Ignition	Switch	Understanding		your	unit helps ensure			top
	Handle		performance,		long service life, and safer
			operation.
			Fuel
			Tank	WARNNG!
	Outer Tube	Throttle
		Trigger	Do not	make	unauthorized		modifica-
Gear Case			tions or alterations to any of these units
			or their	components,
	Cutting
	Attachment Shield
Trimmer	Head
Figure 4

Specifications			E4-$3000
Dry weight		(less attachments)		..................................... lb./5.0		kg
Engine	model				SF2510E
Engine	type			Power Boost	Chamber
Bore x stroke				1.3 x 1.1 in./34	x27 mm
Displacement				1.5 cu. in./24.5		cc
Maximum		power		1.1 HP/0.8		kW
				@ 7500 rpm (mill -1)
Fuel/oil	ratio			50:1 with ISO-L-EGD or JASO FC
				class 2-cyclemixing oil*
Carburetor		type		Walbro WYL, diaphragm-type
Fuel tank capacity				20.3 oz./600		ml

Spark plug			NGK CMR5H
Air cleaner type			Non-reversible heavy-duty
			filter element
Starting	method			Recoil
Stopping	method		Slide switch
Transmission		type	Automatic, centrifugal	clutch
			w/bevel	gear
EPA Emission		Compliance Period**	............................ Category A

**The EPA emission compliance referred to on the emission compliance label located on the engine, indicates the number of operating hours for which the engine has been shown to meet Federal emission requirements.

Category C = 50 hours (Moderate), B = 125 hours (Intermediate) and A = 300 hours (Extended).

Ignition	One-piece electronic,
	program-controlled

Specifications are subject to change without notice.

Swisher E4 engine oil meets or exceeds these specifications and is recommended for all Swisher products.

This unit comes fully assembled with the exception of the cutting attachment shield and cutting attachment.

Prior to Assembly

Before assembling, make sure you have all the components required for a complete unit and inspect unit and components for any damage.

m Engine and shaft assembly

m Cutting attachment

m Kit containing cutting attachment shield

mounting bracket and hardware, this

owner's/operator's manual and tool kit for routine maintenance. Tool kits vary by model and may include a hex wrench

set, a spark plug/screwdriver combina- tion wrench, and a spanner.

The terms "left", "left-hand", and "LH"; "right", "right-hand", and "RH"; "front" and "rear" refer to directions as viewed by the operator during normal operation,