Assembly

and

Adjustments

Cutting Attachment

Shield

Head Cap __

E4-$3000

Screw

 

 

 

 

Outer

 

 

Tube

 

 

Cutting

 

 

Attachment

 

 

Shield

Bracket __-_-i

 

Shim

__

 

Nuts

Line Cutter

I Shim

Cutting

Attachment

Retaining Mounting Plate

Nut

Scre ws

Figure 9

Figure 9A

 

WARNNG!

NEVER operate the unit without the cutting attachment shield installed and tightly secured!

CAUTON!

Make sure the clamp screw and re- taining nut are securely tightened before tightening the four socket-head cap screws.

Install the Cutting Attachment Shield

1.Insert the cutting attachment shield between the outer tube and the cutting attachment mounting plate. See Figure 9.

It may be necessary to loosen the retaining nut and clamp screw to adjust cutting attach- ment shield mounting plate.

E4-$3000

2.Fit the two shims and the bracket over the outer tube and loosely install the four socket-head screws. See Figure 9.

3.Tighten the four socket-head cap screws to secure the cutting attachment shield.

To Change Position of Line Cutter,

The line cutter can be positioned in 2 positions to obtain different line length for cutting.

1.Remove the 2 hex screws with a 4mm hex wrench. See Figure 9A.

2.Rotate line cutter. See Figure 9A.

3.Reinstall the two hex screws and tighten them securely.

_IL WARNNG!

The line cutter is very sharp. Wear gloves to protect your hands when handling.

Be careful to not lose the 2 nuts in the cutting

attachment shield, they are not captured.

Page 7
Image 7
Swisher E4-S3000 manual Install the Cutting Attachment Shield, E4-$3000