Sylvania DVR90DG owner manual Connections, Connection to a TV, This unit, Audio OUT

Connections

Connection to a TV

Before

Antenna

Cable

Cable

Antenna

TV signal

(Back of TV)

or

1

Disconnect

TV signal

or

2

Connect

(Back of TV)

VIDEO AUDIO IN

		4			5
3		Connect			Connect
Connect		Video			Audio
RF cable		cable			cable
		(supplied)			(supplied)
(supplied)
	VIDEO IN	COMPONENT
IN		VIDEO OUTPUT		VIDEO OUT
	IN	S-VIDEO	Y		DIGITAL AUDIO OUTPUT
		OUT
OUT	L			L	PCM / BITSTREAM
			PB/CB
	R			R
ANTENNA	AUDIO IN		PR/CR	AUDIO OUT	COAXIAL
	(L1)

(Back of this unit)

6

Plug in the AC power cord of this unit.

Make one of the following connections, depending on the capabilities of your existing equipment.

Basic Audio

TV

R L

Audio cable (supplied)

This unit

VIDEO OUT

	VIDEO IN	COMPONENT
IN		VIDEO OUTPUT	VIDEO OUT
		S-VIDEO	Y		L
	IN	OUT
OUT	L		L
			PB/CB
	R		R		R
ANTENNA	AUDIO IN		PR/CR AUDIO OUT	COAXIAL
	(L1)

AUDIO OUT

AUDIO OUT

Method 1	Method 2
Better picture	Best picture
	COMPONENT
	VIDEO IN
S-VIDEO IN	Y
	PB/CB
	PR/CR
S-Video cable	Component Video cable
(commercially available)
	(commercially available)
S-VIDEO	COMPONENT
OUT	VIDEO OUTPUT
	Y
	PB/CB
	PR/CR
S-VIDEO OUT	COMPONENT VIDEO OUT

After you have completed connections

•Switch the input selector on your TV to an appropriate external input channel (usually near channel 0). Press a button on the TV’s original remote control (refer to “Input Mode Names for Common TV Brands” on page15) that selects an external input channel until the DVD recorder’s picture appears. Check your TV owner’s manual for details.

you start Connections Getting started Recording Playing discs Editing

Note

•Connect this unit directly to the TV. If the A/V cables are connected to a VCR, pictures may be distorted due to the copy protection system.

•When Progressive Scan mode is selected, no video signal will be output from the VIDEO OUT or S-VIDEO OUT jack.

This unit is compatible with the Progressive Scan System. The feature provides you
with the higher definition images than the traditional output system does. To utilize this		Video - Progressive
feature, you must set Progressive Scan mode to “ON” in the Setup menu by following
		ON
the steps below.		OFF
1. Press [SETUP] to call up the Setup menu.
2.	Select “Playback” using [K / L], then press [ENTER].
3.	Select “Video” using [K / L], then press [ENTER].
4.	Select “Progressive” using [K / L], then press [ENTER].	Video - Progressive
5.	Select “ON” using [K / L], then press [ENTER].	Activating progressive scan:
6.	Select “Yes” using [s / B], then press [ENTER].	Check TV has progressive scan
		and use component video cable.
If your TV is compatible with Progressive Scan (525p / 480p), you must use the		distorted after selecting Yes,
		NOTE: If there is no picture or picture is
Component Video cable (commercially available) to connect this unit to the TV. (See		Wait about 15 seconds for auto recovery.
Method 2 on this page.) Make sure the “P.SCAN” appears on the front panel display.		Activate?	Yes No
If not, use the video cable and set the Progressive Scan mode to “OFF”, or press and
hold [SETUP] for more than 5 seconds, so that the “P.SCAN” on the front panel display
disappears.

Changing the Setup menu Others

Español

13