Sylvania DVR90DG owner manual Functional overview, Front Panel, Rear Panel

Before you start

Functional overview

Front Panel 1

(*) The unit can also be turned on by pressing these buttons.

1.Disc tray

Place a disc when open.

2.Display

Refer to “Front Panel Display Guide” on page 12.

3.OPEN/CLOSE A button*

Press to open or close the disc tray.

4.CHANNEL L / K button

Press to change the channel up and down.

5.REV E button

During playback, press to skip to the previous chap- ter or track.

During playback, press and hold for 1.5 seconds to fast reverse.

When playback is paused, press repeatedly to slow reverse.

6.FWD D button

During playback, press to skip to the next chapter or track. During playback, press and hold for 1.5 seconds to fast forward.

When playback is paused, press repeatedly to slow forward.

7.STOP C button

Press to stop play or recording.

8.PLAY B button*

Press to start or resume play.

Rear Panel	1 2				3
		VIDEO IN	COMPONENT
IN			VIDEO OUTPUT		VIDEO OUT
		S-VIDEO		Y
						DIGITAL AUDIO OUTPUT
		IN	OUT
OUT		L			L	PCM / BITSTREAM
				PB/CB
		R			R
ANTENNA AUDIO IN				PR/CR	AUDIO OUT	COAXIAL
		(L1)
11		10 9	8 7		6	5

1.ANTENNA IN jack

Use to connect an antenna.

2.VIDEO IN jack (LINE1)

Use to connect external equipment with a standard video cable.

3.VIDEO OUT jack

Use to connect a TV monitor, AV receiver or other equipment with a standard video cable.

4.AC Power Cord

Connect to a standard AC outlet to supply power to this unit.

5.COAXIAL DIGITAL AUDIO OUTPUT jack

Use to connect an AV receiver, Dolby Digital decod- er or other equipment with a coaxial digital input jack with a digital coaxial cable.

6.AUDIO OUT jacks

Use to connect a TV monitor, AV receiver or other equipment with standard audio cable.

2	3* 4		5 6 7 8*9
	OPEN/CLOSE	CHANNEL	REV FWD	STOP	PLAY POWER
	REC SPEED REC/OTR
			S-VIDEO	VIDEO	L AUDIO R
15	14	13	1211 10

9.POWER button

Press to turn the unit on and off.

If timer programmings have been set, press to set the unit in timer-standby mode.

10.AUDIO input jacks (LINE2)

Use to connect external equipment with standard audio cable.

11.VIDEO input jack (LINE2)

Use to connect external equipment with a standard video cable.

12.S-VIDEO input jack (LINE2)

Use to connect the S-Video output of external equipment with an S-Video cable.

13.REC/OTR button

Press once to start a recording. Press repeatedly to start a One-touch Timer Recording.

14.REC SPEED button

Press to switch the recording speed.

15.Remote control sensor

Receive signals from your remote control so that you can control the unit from a distance.

4

7.COMPONENT VIDEO OUTPUT jacks

Use to connect a TV monitor with component video inputs with component video cables.

8.S-VIDEO OUT jack

Use to connect the S-Video input of a TV monitor, AV receiver or other equipment with an S-Video cable.

9.S-VIDEO IN jack (LINE1)

Use to connect the S-Video output of external equipment with an S-Video cable.

10.AUDIO IN jacks (LINE1)

Use to connect external equipment with standard audio cable.

11.ANTENNA OUT jack

Use to connect an antenna cable to pass the signal from the TV ANTENNA IN to your TV monitor.

Note

•Do not touch the inner pins of the jacks on the rear panel. Electrostatic discharge may cause permanent damage to the unit.

•This unit does not have the RF modulator.

8