Sylvania LD195SSX Introduction, 5Supplied Accessories, 5Symbols Used in this Manual, Tilt Stand

INTRODUCTION

5Supplied Accessories

owner’s manual	quick start guide	remote control	batteries	Phillips pan screw for
(1EMN24419)	(1EMN24605)	(NF033UD)	(AA x 2)	attaching the stand x 3
				(FPH34120)
				AA
				AA

•If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free customer support line found on the cover of this manual.

5Symbols Used in this Manual

The following is the description for the symbols used in this manual. Description refers to:

TV FUNCTIONS

DVD FUNCTIONS

TV : Analog TV operation

DTV : Digital TV operation

•If neither symbol appears under the function heading, operation is applicable to both.

DVD : Playback of DVD-video

CD : Playback of audio CD

•If neither symbol appears under the function heading, operation is applicable to both.

5Attaching the Stand

You must attach the stand to the unit to display upright. Be sure the front and rear of the stand match the proper direction.

1 Spread a thick and soft cloth over a	2 Hang the hook under the bottom
table.	of the main unit to the stand’s hole
Place the main unit face down onto it.	(shown arrow ➀), then slide down the
Make sure not to damage the screen.	stand in the direction of the screen
	(shown arrow ➁). Make sure not to
	put the AC power cord between the
	stand and the unit.



3 Drive Phillips pan screws in the 3 threaded holes at the bottom of the stand with a screwdriver tightly.

Žscrew holes

front side

To remove the stand from this unit

Unscrew the Phillips pan screws indicated by “➂”. Pull up the stand in the direction of the rear of the unit. Be careful not to drop the stand when you remove it.

Œ

Œ

Note:

•When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall, resulting in injuries as well as damage to the unit.

•Make sure to use a table which can support the weight of this unit and is larger than this unit.

•Make sure the table is in a stable location.

	-2.5°	°
5Tilt Stand		10

You can adjust the stand to change the angle of the unit (-2.5° to 10°).

4

EN