Español Français English

Stereo Sound Mode

CD

This unit allows you to select a sound mode during CD playback.

During playback, press [AUDIO] repeatedly until the desired sound mode appears.

STEREO

Each time you press [AUDIO], the sound mode changes as example below.

Marker Setup

This feature allows you to assign a specific point on a disc to be called back later.

To set a marker

1During playback, press [MODE] repeatedly until “” / “” appears.

e.g.) DVD

_ _ /12 (SEARCH)

2Use [Cursor K/ L] repeatedly until marker search menu appears.

INTRODUCTION PREPARATION WATCHING

STEREO (stereo sound with left and right channels)

L-ch(left channel sound only)

or

1 2 3 4 5 6 7 8 9 10 AC

TV

R-ch(right channel sound only)

Note:

Virtual surround cannot be changed when the sound mode is set to either “L-ch” or “R-ch”.

Virtual Surround

You can enjoy virtual surround on your 2 channel stereo system.

1During playback, press [MODE] repeatedly until “” appears.

OFF (SURROUND)

2Press [Cursor K/ L] to select the sound level.

or

(SURROUND)

1

1 : Natural effect.

2 : Emphasized effect.

OFF : No effects (original sound).

3Press [BACK] to exit.

Note:

The setting will be kept even if the unit is turned off.

For audio CD, virtual surround will not be effective if the sound mode is set to something other than “STEREO”. (Refer to “Stereo Sound Mode” on page 43.)

Turn down the level or select “OFF” if the sound is distorted.

3Use [Cursor s / B] to select an available marker within 60 seconds.

1 2 3 4 5 6 7 8 9 10 AC

4When the playback reaches the point at which you want to set a marker, press [ENTER].

• Marker is now set.

2 3 4 5 6 7 8 9 10 AC

5Press [BACK] to exit.

To return to the marker later

1Repeat steps 1-2 in “To set a marker”. Use [Cursor s / B] to select the desired marker.

e.g.) DVD

2 3 4 5 6 7 8 9 10 AC

2Press [ENTER] at the desired marker to restart playback from the specific point which you set.

2 3 4 5 6 7 8 9 10 AC

Note:

Marker search menu will disappear in about 60 seconds when there is no input.

You can mark up to 10 points.

To clear a marker, select the marker to be cleared, and then press [CLEAR].

Ejecting the disc or turning off the power will erase all markers.

Selecting “ ” at step 3 in the section “To set a marker” will also erase all markers.

OPTIONAL SETTING OPERATING DVD DVD SETTING TROUBLESHOOTING INFORMATION

43

EN

Page 43
Image 43
Sylvania LD195SSX owner manual Stereo Sound Mode, Marker Setup, Virtual Surround