Sylvania LD320SS2 PREPARATION, Antenna Connection, Connection to Cable Receiver or Satellite Box, Plug In the AC Power Cord, Before you connect:, the Component Video connector

12

PREPARATION

No supplied cables are used with these connections:

• Please purchase the necessary cables at your local store.

Before you connect:

Be sure your antenna or other device is connected properly before plugging in the AC power cord.

Antenna Connection

Connect the RF coaxial cable on your home outlet to the antenna input jack of this unit.

VHF / UHF

analog or

DTV antenna

or

RF coaxial cable

cable TV signal

Once connections are completed, turn on the unit and begin initial setup. Channel scanning is necessary for the unit to memorize all available channels in your area. [Initial Setup]

➠p.13

Note

•If you have any question about the DTV’s antenna, visit www.antennaweb.org for further information.

•Depending on your antenna system, you may need different types of combiners (mixers) or separators (splitters). Contact your local electronics store for these items.

•For your safety and to avoid damage to this unit, please unplug the RF coaxial cable from the antenna input jack before moving the unit.

•If you did use an antenna to receive analog TV, it should also work for DTV reception. Outdoor or attic antennas will be more effective than a set top or inside antenna.

•To switch your reception source easily between antenna and cable, install an antenna selector.

•If you are not receiving a signal from your cable service, contact the Cable provider.

Connection to Cable Receiver or Satellite Box

Use an HDMI or component video cables to connect the HDMI or the Component Video Input jacks of the unit to the HDMI or the component video output jacks of the cable receiver / satellite box.

If you connect to the unit’s Component Video Input jacks,

connect audio cables to the Audio L/R Input jacks right beside
the Component Video connector.
				component video cables
				(red / blue / green) and audio cables
(green) (blue)	(red)
COMPONENT VIDEO OUT		AUDIO OUT		HDMI OUT
Y Pb/Cb	Pr/Cr	L	R

or

STEREO

PCM

cable receiver / satellite box

ANT IN

HDMI cable

or

satellite dish

RF coaxial cable

or

cable TV signal including PPV

You can also connect this unit to the cable receiver or satellite box other than the HDMI or the component video output jacks because they might have different output jacks.

Required cables and connecting methods of the cable receiver/ satellite box, or the availability channel for the clear QAM may differ depending on the cable/satellite provider.

For more information, please contact your cable/satellite provider.

Note

•Use an HDMI cable with the HDMI logo (a certified HDMI cable). High Speed HDMI cable is recommended for the better compatibility.

Plug In the AC Power Cord

Make sure that the AC power cord must be plugged to an AC outlet after all the necessary connections are made.

Caution:

•Do not connect the AC power cord to a power supply outside the indicated voltage of this unit (AC 120V).

Connecting the AC power cord to a power supply outside of this range may result in fire or electrical shocks.

Note

•Each time you plug in the AC power cord, no operations will be performed for a few seconds.This is not a malfunction.