MusicLites Module
(Part number 72284)
What comes with the MusicLites module?
•1 ML Loudspeaker with Light
•Owner’s Manual
•Instructions for first time
•Screwdriver
What does the MusicLites module do?
The MusicLites modules combine light and audio into an experience that must be seen and heard to be believed. In order to use, you will need to purchase one of the 3 transmitters available.
How does the MusicLites module work?
(1)Before you screw the MLs into the socket, make sure to set up the house code, zones and channels from the rear of each unit:
a.Set up the house codes- Make sure the house code is set to the proper code (default is 0). If not, take the screwdriver provided and turn to the correct house code. All MLs must be set to the same house code as must all transmitters and remote controls in order to work as one system.
b.Set up the zones- If you are putting in multiple zones, you should plan out how many MLs
are in each zone (up to 12) and to mark the zones on the back of each remote control to make sure you remember which zone you are controlling. The default setting is zone 1. If you are only putting in 1 zone, then leave as set up from the factory.
c.Set up the audio channels- Determine which MLs are left speakers, right speakers or operating as both left and right speakers. Refer to page 5.
(2)Once you have the MLs switches in the correct positions, install the units in the fixtures according to those settings. Mixing two zones in the same room may cause a lot of confusion.
(3)Turn the MLs on at the wall switch and make sure the light is working. If the light comes on, you are ready to play.
(4)To synchronize with an audio source, press the zone button on the remote corresponding to the zone you want to control. Then press the S1, S2 or S3 button on the remote corresponding to the transmitter you want to play.
NOTE: To check on the source being received properly, you can turn the light off with the remote. Then, press the correct source button. If you press S1, the blue light on the ML should blink once before going off.
(5)Provided the source device is on and functioning and that the sources are in synchronization, you should hear the speakers playing. If not, you will need to work through troubleshooting steps. You can find these on the www.musiclites.com web site under ‘Troubleshooting FAQ’s.’
13
