Helpful Hints:
On wooden cabinets you may want to mark and start the drill holes with a nail or an awl. Be sure to hold the
drill very firmly against the cabinet to reduce “walking” of the drill bit from the markings.
Using masking tape above the hole locations on inside of wooden cabinet shelf to help reduce splintering.
If installing the unit under a wood cabinet, you may wish to countersink the drilled hold for the INSIDE of the
cabinet if a countersink the holes use the supplied washers.
Step 3
Remove template and clean drill shavings from inside and underside of cabinet.
Step 4
If your cabinet does not have an overhang. Go to Step 5.
If your cabinet has an overhang. Select the spacer or combination of spacers that is equal to or longer than the
cabinet overhang.
Step 5.
Insert screws from inside the cabinet. The washers must be used on metal cabinets, and on wood cabinets if you
did not countersink the drilled holes. Position washers, flat side down, and place screws into the holes.
If your cabinet does not have an overhang, go to Step 7.
Step 6.
Hold screw heads down while you push the selected spacers onto the screws under the cabinet. Be sure to push
up spacers until they fully nested (if more then one is in used)
Step 7
Align radio under the screws. Hold the screw holes in the top of the clock radio against the mounting screws
and partially tighten the screws.
Do not fully tighten until all 3 screws have been started. (The top front edge of the clock radio should clear the
overhang.)
It is for rounding the extra power wire after user had plugged the power cord to the electrical outlet.