Sylvania SY4100 Replace the Battery, Notes on the Position when Installed, Zone Address Setting

Replace the Battery

•When the sensor sends a low battery message to main console, remove the old battery and replace it with a fresh alkaline battery. The LCD is shown below

63 PIR SENSOR

01 Low battery

Zone Address Setting

Enter the Installer password and press “1” to activate the “Sequence Programming Menu” after installing the battery for the PIR sensor. Set the power switch from “ OFF ” to

“C ” position. The red LED will blink for 1 second and activate the PIR sensor by moving in front of the PIR Sensor. The Main Console will emit one ‘Beep’ and the LCD will display, ‘Sensor Added’. The PIR sensor has been programmed into the main console successfully.

When the main console is in the armed mode, the PIR detects movement of human or animals (cat, dog). A message will be displayed on the LCD as shown below.

63 PIR SENSOR

01 Zone

Notes on the Position when Installed

The PIR Motion sensor detects the movement of humans and animals within their range. In order to prevent false alarms , we recommend that you do not install any motion sensor in the following areas:

Do not install any PIR motion sensor in the following areas:

•Where there is a device that causes rapid temperature change or rapid heat transfer. For instance, near an air conditioner, fire place, heater or other intermittent heat sources.

•Where the sensor will be exposed to direct sunlight.

•Near large electrical devices and/or high output radio frequency sources, like a refrigerator, microwave, computer, or light dimmer.

•Where the effective range of the sensor is covered or blocked by furniture.

•Where pets enter and exit freely, for instance - a cat or dog door.

•Directly opposite any large object with flat reflecting properties, like large windows or mirrors.

•In a bathroom or other area that is exposed to moisture and extreme temperature change.

Installing the PIR Motion Sensor

Before installing the sensor, consider the following points:

•Mount the sensor two meters (6-1/2’) high for best coverage.

•Mount the sensor with a 14 degree downward incline angle against the wall for optimum range.

18