Change the Battery
When the sensor sends a low battery message to the main console, remove the old battery and replace it with a fresh alkaline battery. The low battery message on the LCD is shown below
63 WINDOW SENSOR
01 Low battery
Zone address setting
You can set the sensor as “ Door “ or “ Window “ detector by using the jumper selector. If you want to set the sensor as a Door sensor, put the Jumper on the “D” side. (If the set Jumper is on the “W” side, the sensor becomes a Window sensor).
DOOR / WINDOW
SELECT
DOOR / WINDOW
SELECT
TYPE S
TYPE SEL
JUMPER
DOOR
WINDOW
DC 12V |
JUMPE
DC 9V | W |
|
Notes on the Door/Window Detector
1.The LED on the sensor will flash once when the sensor is triggered.
2.There cannot be a gap greater than 1/4 inch (5 mm) between the magnet sensor and the magnet, otherwise, the sensor will not work properly.
Enter the installer password and press the “1” button to activate the “Sequence Programming Menu”. Take the magnet away from the magnet sensor. It will trigger the sensor and the LED will light for 1 sec. The Main Console will emit one ‘Beep’ and the LCD will display, ‘Sensor Added’. The sensor has programmed into the main console successfully.
LCD display on the Main Console for Door/Window Detector
When the system is in the armed mode. (message shown on main console)
∙ | Window opened | Door opened |
63W INDOW SENSOR 01 Open
63DO O R SENSOR 01 Open
20